[1]王立垒,李彦来,刘 东,等.聚合物滞留量预测模型研究及应用[J].复杂油气藏,2019,12(02):55-58.[doi:10.16181/j.cnki.fzyqc.2019.02.012]
 WANG Lilei,LI Yanlai,LIU Dong,et al.Research and application of the polymer retention theoretical model[J].Complex Hydrocarbon Reservoirs,2019,12(02):55-58.[doi:10.16181/j.cnki.fzyqc.2019.02.012]
点击复制

聚合物滞留量预测模型研究及应用()
分享到:

《复杂油气藏》[ISSN:1674-4667/CN:31-2019/TQ]

卷:
12卷
期数:
2019年02期
页码:
55-58
栏目:
油气开发
出版日期:
2019-06-25

文章信息/Info

Title:
Research and application of the polymer retention theoretical model
作者:
王立垒李彦来刘 东张俊廷祝晓林
中海石油(中国)有限公司天津分公司渤海石油研究院,天津 300459
Author(s):
WANG Lilei LI Yanlai LIU Dong ZHANG Junting ZHU Xiaolin
Bohai Oilfield Research Institute of Tianjin Branch of CNOOC Ltd., Tianjin 300459, China
关键词:
滞留特性 聚合物驱 残余阻力系数 油藏数值模拟
Keywords:
retention characteristic polymer flooding residual resistance factor reservoir numerical simulation
分类号:
TE357.46
DOI:
10.16181/j.cnki.fzyqc.2019.02.012
文献标志码:
A
摘要:
针对聚合物驱中聚合物滞留量定量预测难,导致聚合物驱油效果难以准确预测的问题,通过理论公式推导,建立了岩心极限滞留量预测模型,定量刻画了聚合物驱极限滞留量与岩石的密度、孔隙度和聚合物浓度之间的关系,并绘制出聚合物原始浓度与有效浓度和浓度保留率关系的理论图版。以渤海LD聚驱油田典型参数为基础,建立了数模机理模型,定量分析了滞留量对聚合物驱油效果的影响,并基于实验规律创建了残余阻力系数随滞留量变化的公式。应用该公式最终优化得到了聚合物驱的最佳滞留量。研究结果可用于滞留实验结果的校正以及聚合物驱中聚合物干粉的选型。
Abstract:
In view of the problem of the influence of polymer retention on polymer flooding effect, the calculation model of core limit retention was established by theoretical formula,to quantitatively depict the relationship of polymer flooding limit retention amount to the rock density,porosity and polymer concentration, and draw the theoretical relationship plate between the original concentration of polymer and the effective concentration and the retention rate. On this basis, the influence of the retention on the polymer flooding effect was quantitatively analyzed by establishing the mechanism model of the typical oilfield. Based on the experimental rule, the formula of the residual resistance factor with the change of the retention amount was created, and the optimum retention amount was finally optimized by using the formula. The research results can be used for correction of retention experiment results and selection of polymer dry powder in polymer flooding.

参考文献/References:

[1] 黄颖辉,刘东,李金蔓,等.弱凝胶矿场调驱效果评价方法研究[J].油气藏评价与开发,2013,3(2):62-65.
[2] 蔡晖,马奎前,黄志伟,等.弱凝胶调驱技术在海上稠油开发中的应用[J].重庆科技学院学报(自然科学版),2011,13(2):59-61.
[3] 刘东,李云鹏,张风义,等.弱凝胶提高海上稠油油田采收率影响因素分析[J].特种油气藏,2013,20(2):84-86.
[4] 刘冰.大庆油田西区二类油层三元复合驱方法[J].东北石油大学学报,2016,40(4):106-113.
[5] 郭文敏,刘同敬,秦积舜,等.大庆油田聚合物驱后周期分质注聚合物技术[J].石油学报,2010,31(3):449-451.
[6] 李宜强,隋新光,李斌会.聚合物驱后提高采收率方法室内实验研究[J].石油学报,2008,29(3):405-408.
[7] 刘东,李云鹏,张风义,等.烟道气辅助蒸汽吞吐油藏适应性研究[J].中国海上油气,2012,24(增1),62-66.
[8] 刘东.热采水平井加热半径计算新模型[J].中国海上油气,2015,27(3):84-90.
[9] 刘东,胡廷惠,潘广明,等.海上稠油多元热流体与蒸汽吞吐开采效果对比[J].特种油气藏,2015,22(4):118-120.
[10] 王天源,修建龙,黄立信,等.多孔介质微生物提高原油采收率模型[J].石油学报,2010,37(1):97-105.
[11] 赵福麟.EOR原理[M].东营:中国石油大学出版社,2006:65-87.
[12] BAYPUMI N, El-EMAM, Kamal O, et al. The effect of polymers on the displacement of Nubia crude oil(October field)[J].JCPT,1997,36(2):42-48.
[13] LITTMANN W. Polymer flooding[M]. Amsterdam-Oxford-New York-Tokyo: Elsevier,1988:3-9.
[14] BARREAU P, LASSEUX D, BERTIN H. Polymer adsorption effect on relative permeability and capillary pressure: investigation of a pore scale scenario[R]. SPE 37303,1997.
[15] 刘锦成.聚合物凝胶降低水相渗透率大于油相的机理研究[J].国外油田工程,1996(10):10-12.
[16] 石京平,杨清彦,刘成芬,等.聚合物溶液吸附对油层物性影响的试验研究[J].石油天然气学报(江汉石油学院学报),2005,27(1):224-227.
[17] 吕凯,戴彩丽,张若然.疏水缔合聚合物在地层多孔介质吸附特性研究[J]. 油田化学,2010,27(4):391-393.
[18] 熊启勇,陈国锦,韩晓强.部分水解聚丙烯酰胺在地层多孔介质吸附特性研究[J].新疆石油科技,2005,15(1):37-40.
[19] 李华斌,尚育秋.疏水缔合聚合物在孔隙介质上的静态吸附特征[J].大庆石油地质与开发,2006,25(5):93-95.
[20] 孟中华,刘平礼,吴媛媛.聚合物的静态吸附机理研究[J].石油天然气学报(江汉石油学院学报),2010,32(6):315-318.

备注/Memo

备注/Memo:
收稿日期:2018-10-09; 改回日期:2018-12-15。
第一作者简介:王立垒(1984—),现主要从事油田开发、化学驱效果跟踪评价与方案调整等方面研究。E-mail:wangll10@cnooc.com.cn 。
基金项目:国家科技重大专项“渤海油田加密调整及提高采收率油藏工程技术示范”(2016ZX05058001)。
更新日期/Last Update: 2019-06-25