[1]李明.裸眼水平井多级分段压裂技术在义123-1块的应用[J].复杂油气藏,2014,(02):65.
　Li Ming.Application of multi-stage fracturing technology for open-hole horizontal well in block Y123-1[J].Complex Hydrocarbon Reservoirs,2014,(02):65.
点击复制

裸眼水平井多级分段压裂技术在义123-1块的应用
分享到：

《复杂油气藏》[ISSN:1674-4667/CN:31-2019/TQ]

卷:
期数:
2014年02期
页码:
65
栏目:
油气工程
出版日期:
2014-06-25

文章信息/Info

Title:
Application of multi-stage fracturing technology for open-hole horizontal well in block Y123-1
作者:
李明
中国石化胜利油田分公司采油工艺研究院，山东东营257000
Author(s):
Li Ming
Production Technology Research Institute of Shengli Oilfield Company,SINOPEC，Dongying,Shandong 257000
关键词:
压裂　裸眼　水平井　连续混配
Keywords:
fracturing; open-hole; horizontal well; continuously mixing
分类号:
TE357.1
文献标志码:
A
摘要:
义123-1块目的层埋深3384~3757m，属中低孔特低渗油藏，采用常规直井压裂开发，产量递减快，效果差。针对埋藏深、温度高、油层多且薄的问题，通过对地质条件的分析，确定了技术的可行性，通过对井眼垂向位置、段间距、压裂规模、裸眼分段工具等的优化以及连续混配型压裂液的研制，形成了水平井裸眼封隔器+投球滑套多级分段压裂技术，并成功应用于该区块。目前已成功实施12井次，均自喷生产，累计产油32067t，压后产量达到同区块直井的5~6倍，取得了较好的增产效果。
Abstract:
The target reservoir in block Y123-1，buried in depth from 3,384 to 3,757 meters，belongs to low porosity and low permeability ones.If the conventional fracturing technology for vertical well is used，it will be shown that rapid decline in production and bad development effect.Aiming at problems in deep buried，high temperature，and multiple thin layers，through analyzing geological conditions，the feasibility of fracturing technology was discussed.Based on parameter optimization such as vertical position of borehole，section space，fracturing scale and open-hole staged tools，and the development of continuously mixing fracturing fluid，the multistage fracturing technology by open-hole packer and ball sliding sleeve for horizontal wells was formed.The technology was successfully applied in 12 wells in the block.After fracturing，average production rate of 12 wells was 5 to 6 times than that of vertical well in the block，and in flowing production.Up to now，cumulative oil production is 32,067t，showing good yield-increasing production.

参考文献/References:

［1］王端平,时佃海,李相远，等.低渗透砂岩油藏开发主要矛盾机理及合理井距分析［J］.石油勘探与开发，2003,30(1):87-89.
［2］陈作,王振铎,曾华国.水平井分段压裂工艺技术现状及展望［J］.天然气工业,2007,27(9):78-80.
［3］李宗田水平井压裂技术现状与展望［J］.石油钻采工艺,2009,31(6)：13-18.
［4］朱正喜,李永革.苏里格气田水平井裸眼完井分段压裂技术研究［J］石油机械,2012,40(5):78-81.
［5］Abass H H.Non-plannar fracture propagation from a horizontal wellbore：experimental study［J］.SPE24823,1992.

备注/Memo

备注/Memo:
收稿日期：2013-07-30；改回日期：2013-08-20
作者简介：李明（1981—），工程师，现主要从事压裂工艺及储层改造研究工作。电话：18654615809，E-mail：limingupc@163.com。
基金项目：国家重大科技专项《大型油气田及煤层气开发》（2011ZX05051）
更新日期/Last Update: 2014-06-25