[1]尚宝兵,李俊飞,吴华晓,等.海上高凝油油藏开发技术对策研究[J].复杂油气藏,2018,(04):65.[doi:10.16181/j.cnki.fzyqc.2018.04.014]
　SHANG Baobing,LI Junfei,WU Huaxiao,et al.Technical development measures of offshore high pour-point oilfield[J].Complex Hydrocarbon Reservoirs,2018,(04):65.[doi:10.16181/j.cnki.fzyqc.2018.04.014]
点击复制

海上高凝油油藏开发技术对策研究()
分享到：

《复杂油气藏》[ISSN:1674-4667/CN:31-2019/TQ]

卷:
期数:
2018年04期
页码:
65
栏目:
油气工程
出版日期:
2018-12-25

文章信息/Info

Title:
Technical development measures of offshore high pour-point oilfield
作者:
尚宝兵; 李俊飞; 吴华晓; 牟 媚; 于法浩
中海石油(中国)有限公司天津分公司,天津 塘沽 300452
Author(s):
SHANG Baobing; LI Junfei; WU Huaxiao; MU Mei; YU Fahao
Tianjin Branch of CNOOC Ltd.,Tianjin 300452,China
关键词:
高凝油 油藏开发 储层敏感性 注水温度 隔热油管 防蜡
Keywords:
high pour-point crude oil;  reservoir development;  formation sensitivity;  temperature of injection water;  vacuuminsulated tubing;  wax control
分类号:
T122
DOI:
10.16181/j.cnki.fzyqc.2018.04.014
文献标志码:
A
摘要:
渤海K油田是典型的高凝油油藏,高效开发难度大。为此,对储层原油及储层敏感性进行了评价研究,并开展了相应的注采技术对策研究。注水工艺上,建立了注水井井筒温度场计算模型,优化了注水井的注水温度。采油工艺上,推荐油井采用隔热油管保温生产,通过提高产液温度防止井筒结蜡。研究结果表明,该油田储层水敏和酸敏较为严重; 为防止注水引起的地层冷伤害,井口注水温度应不低于60℃; 为达到防蜡目的,油井隔热油管下深为600～1 500 m。现场实施效果表明,油田投产后注水温度满足设计要求,注水水质稳定; 油井井筒中未出现结蜡问题,生产稳定,充分发挥出了该油田的生产潜能,促进了海上油田的高效开发。
Abstract:
Bohai K Oilfield is a typical high pour-point oilfield, which is difficult to develop efficiently. Based on the characteristics of the oilfield,the sensitivity of crude oil and reservoir was evaluated.Corresponding measures of injection and production technologies were studied to improve the development effect. In the injection aspect, it was established a wellbore temperature field calculation model for water injection wells, and the temperature of injected water was optimized.In the production aspect,vacuum-insulated tubing was recommended for wax control through increasing temperature of production fluid.Research result showed that the formation is serious water and acid sensitivity. To prevent the formation cold damage, the temperature of injected water should not be less than 60 ℃.The setting length of vacuum-insulated tubing is about 600 m to 1 500 m to control wax deposition. Field results indicated that after the oilfield putting into production, the temperature of injected water meets the design requirement. Non-wax problem occurred in wellbore is benefit to guarantee stable production. All of these measures promoted the high-efficient development of this oilfield.

参考文献/References:

[1] 郑爱玲,刘德华.涠洲W断块高凝油油藏开发对策[J].特种油气藏,2015,22(2):123-125.
[2] 敬加强,杨莉,秦文婷,等.含蜡原油结构形成机理研究[J].西南石油学院学报,2003,25(6):49-52.
[3] 刘海庆,姚传进,蒋宝云,等.低渗高凝油藏堵塞机理及解堵增产技术研究[J].特种油气藏,2010,17(6):103-106.
[4] 廖长霖,吴向红,王喻雄,等.南苏丹高凝油油藏冷伤害机理研究[J].西安石油大学学报(自然科学版),2016,31(4):64-67.
[5] 田乃林,冯积累.早期注冷水开发对高含蜡高凝固点油藏的冷伤害[J].中国石油大学学报(自然科学版),1997,21(1):42-45.
[6] 刘慧卿,毕国强.北小湖油田油层冷伤害实验研究[J].中国石油大学学报(自然科学版),2001,25(5):45-47.
[7] 高明,宋考平,吴家文.高凝油油藏注水开发方式研究[J].西南石油大学学报(自然科学版),2010,32(2):93-96.
[8] 邓惠,杨胜来,康铭辉,等.高凝油常规冷采时井筒温度分布分析[J].特种油气藏,2008,15(5):91-93.
[9] 管虹翔,李成见,李萍,等.隔热油管技术应用于海上稠油常规生产井数值模拟分析[J].中国海上油气,2008,20(4):257-260.
[10] 姚传进,雷光伦,蒋宝云,等.高凝油井筒温度场计算及流态转变分析[J].石油钻采工艺,2011,33(3):42-46.
[11] 周赵川,王辉,代向辉,等.海上采油井温度计算及隔热管柱优化设计[J].石油机械,2014,42(4):43-48.
[12] 姚为英.高凝油油藏注普通冷水开采的可行性[J].大庆石油学院学报,2007,31(4):41-43.

备注/Memo

备注/Memo:
收稿日期:2018-06-21。第一
作者简介:尚宝兵(1988—),工程师,从事采油工程设计、注水工艺设计等相关研究工作。E-mail:shangbb@cnooc.com.cn。
基金项目::“十三五”国家科技重大专项(2016ZX05058-003-019)。
更新日期/Last Update: 2018-11-25